Clear you cmos settings.  Check your manual.  You may have a jumper that you
can move or just pull the battery for a couple of minutes.  You've set
something in the bios to a setting your board won't post with.

Ben Moore


----- Original Message -----
From: "jerry crider" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, September 04, 2002 10:55 PM
Subject: [PCBUILD] no flash??


hello listers again,well i aint sure about the mobo.but it has a 633 intel
flip chip its on a older board it has sis chip set 630 i think well i
replaced the ps in it and it was working fine i went in to set up and
changed the cpu setting to a slower setting i think? and when i exited setup
it rebooted but it give a blank scren?all the lights lite up and the fans
are on but the monitor stays in rest mode ?has this happ. to any one else is
it the bois or did i mess some thing up and  how do i get it back up to
reset it.. ???? any help would be great . thanks agian  in addvance,jerry
the fat boy crider

              The NOSPIN Group is now offering Free PC Tech
                     support at our newest website:
                          http://freepctech.com