Subject: | |
From: | |
Reply To: | |
Date: | Mon, 13 Aug 2001 21:07:57 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hello All
II use an older Yaesu one with piano key controls for stop, left and
right rotate.
it is inaccessible inso far that I cannot read the screen.
The control of the rotator is usually by a low DC voltage so I guess
using a VCO could be a way of finding out which way the beam is
pointing.
Here in the U.K. it is difficult to get hold of those which have a
knurled rotary central protrusion. If you can get hold of one of this
kind, then you can notch out the edge above the pointer.
I am in the process of establishing a station in my /p qth by the sea,
about 100 miles from here, and I will be putting a parallel port
controlled rotator in situ.
All my logging is done on the PC and I think this is a sensible
approach in my situation.
As mentioned on the list before, I use two DOS logging programs which do
all that any dx-er wants.
73 de Dave - G3YXX
In message <[log in to unmask]>, Mike Freeman
<[log in to unmask]> writes
>Who wants to fiddle with a computer just to turn a
>beam/quad/quagi/colinear/etc.?
>
>Mike Freeman <[log in to unmask]>
>Amateur Radio: < K 7 U I J >
>... Go M's!!!!!
>
>On Mon, 13 Aug 2001, Brett Winchester wrote:
>
>> Is there the prosearch anymore that would take computer control input?
>>
>> Thank You!
>>
>> BRETT K WINCHESTER PM KD7JN
>> mailto:[log in to unmask]
>> http://www.icbvi.state.id.us/brochure/RADIO.HTM=20
>>
>> READING SERVICES MANAGER
>> ICBVI - IDAHO COMMISSION f/t BLIND & VISUALLY IMPAIRED
>> P O BOX 83720
>> BOISE IDAHO 83720-0012
>> 208-334-3220 ext 104 or 103 +7 =3D voice mail non-business hours
>> fax 208-334-2963
>>
>> >>> "Nathan, Kevin" <[log in to unmask]> 08/13/01 11:35AM >>>
>> Hi All,
>>
>> I was recently able to acquire a tower very reasonably and am going to put
>> up some directional antennas. For the moment, this will consist of a
>> combination 6 meter and 2 meter quad but eventually I will add something =
>> for
>> the lower bands although it would be no bigger than a three element =
>> triband
>> beam or quad and perhaps something a little smaller.
>>
>> Can you all make some recommendations for a rotator which would accommodate=
>>
>> my needs and which is easily operated by a totally blind person?
>> Affordability would be a good factor as well. <GRIN>
>>
>> Thanks so much in advance for your help and 73.
>> Kevin, K7RX
>>
>> Kevin Nathan, Independent Living Coordinator
>> Department of Services for the Blind
>> 3411 S. Alaska
>> Seattle, Wa 98118
>> Voice: (206) 721-6450
>> Toll Free: (800) 552-7103
>> Fax: (206) 721-6403
>> Email: [log in to unmask]
>>
--
David
|
|
|