> I damaged a printer port in a bid to connect a printer to to a PC
> that was on. This affected the floppy drive and serial port. I bought an
> I/O card the floppy dirve now works fine but I still have a problem
> configuring the printer port. I have disabled the onboard printer port in
> the CMOS setup but nothing seems to help. I get an error in the device
> manager that this device is not working properly. Does any one have a
> solution to this configuration problem?
Most likely has happened is that device manager has not "noticed" that you
disabled the onboard port and hasn't "seen" the new port. Try deleting the
LPT port in device manager and rebooting, see if it picks up the new port.
If it doesn't (which is likely if the new card doesn't support plug and
play) install the port manually with the "new hardware" wizard. TTYL
Do you want to signoff PCBUILD or just change to
Digest mode - visit our web site:
http://freepctech.com/pcbuild.shtml