Hi all,

Not long ago I installed an Abit BE-6II Motherboard with Highpoint ATA 66
controllers.  My primary drive (WD 10 Gig Caviar I think it is) is attached
to these controllers while my second drive is attached to the slower ATA 33
controllers.  The BIOS ? screen at boot up specifically for the highpoint
controllers says that the primary drive is running in UMDA mode 4 but
what's a good way to verify that my hard drives are running at the speed
they're suppose to.

Thanks for any info.,

Bill Nussbaumer

                         PCBUILD's List Owner's:
                      Bob Wright<[log in to unmask]>
                       Drew Dunn<[log in to unmask]>