[log in to unmask] wrote:
> In a message dated 01/17/2000 11:21:49 PM Eastern Standard Time,
> [log in to unmask] writes:
>
>
> Thanks again to all who helped.
> Brad Loomis
> Los Angeles, CA >>
>
> Hi,
> I see from your post you are setting one of the drives to ID 0 (zero). As I
> recall, ID 0 is reserved for the SCSI controller itself, and is not supposed
> to be used for any other device. You might try resetting ID #'s on the
> drives, so as not to use ID 0, and see if that helps.
The controller is usually SCSI ID 7, SCSI ID 0 is typically the first SCSI
(boot) drive.
--
Russ Poffenberger Engineering Specialist
Schlumberger Technologies ATE DOMAIN: [log in to unmask]
1601 Technology Drive
San Jose, Ca. 95110 Voice: (408)437-5254 FAX: (408)437-5246
PCBUILD's List Owner's:
Bob Wright<[log in to unmask]>
Drew Dunn<[log in to unmask]>