Subject: | |
From: | |
Reply To: | |
Date: | Wed, 5 Aug 1998 20:21:12 +0200 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
on 05.08.98 you wrote
>I cannot get my computer to recognize
my serial mouse
<snip>
Hello Ray, I have a few questions about
your problem
1: have you tried using a ps/2 mouse (I
know not everyone
has a connector, but maybe you can get
one somewhere)
2: have you tried using a printer. Does
it work?
3: Have you tried to use a mouse in dos.
the EDIT program in WIN 95 is a dos
prog.that uses a mouse.
Boot in dos mode and load a dos mouse
driver then start EDIT.
Can you use the mouse to cut and paste?
4: have you installed a NON MS mouse
driver for WIN 95.
By this I mean a no name mouse that has
it's own win95 Driver
(usually xxMOUSE.vxd where xx might be
anything)somewhere on
the disk. This has worked for me
once,but I wouldn't bet on it.
If you can't find one, E-Mail me and
I'll
send you one of mine.
I downloaded your manual, and I think
the
>5 pins that say MS_JMP on one end and
PS/2_JMP on the other
is your PS/2 Mouse connector (according
to the Manual: PS/2_MS)
What Ubiratan was referring to with
>If you changed your board don't forget
that the old male DB9
>connectors have diferent conection with
the flat cable.
<snip>
was the different pin-out between
COM-ports on new boards and
old serial connector cables (or the
opposite), but I don't
think this is the problem here.
Rick Swartz ( [log in to unmask] )
|
|
|