Subject: | |
From: | |
Reply To: | |
Date: | Fri, 1 Sep 2000 11:25:51 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
At 04:43 PM 08/31/2000 , Gary Kaucher wrote:
>I bought a used PC with 128 MB (4 chips at 32 MB each) of RAM. I would like
>to install all 4 chips in my PC. The chips all fit into the 4 available
>slots, but when I boot up, they are apparently unrecognized, and all I get
>is a blinking power light on the monitor. Do I have to do anything to make
>the chips work. I don't remember doing anything before. When I put the old
>chips (2 - 8 MB and 2- 16 MB) back into the slots, they are recognized no
>problem. Any advice appreciated
Since you mention 8mg chips, I assume these are simms and not dimms.
I would consider that the new chips are either non-parity or parity
simms, a form of ram your PC does not support. You might check the
Bios to see if you have a setting to change this option...
Another issue might be to check the speed you have the Bios set at for
Ram and set it to auto if at all possible.
If these two are not issues, you might want to install the simms two at
a time to determine if one or more of them are bad.
Bob Wright
The NOSPIN Group
Curious about the people moderating your
messages? Visit our staff web site:
http://nospin.com/pc/staff.html
|
|
|