I have no other parallel port on my computer other than my printer port,
which is already pre set into the board. its a plug n play with no jumpers.
it only has one port on it.

>This sounds like a conflict between the card and some other hardware.  Do
>you have a parallel port on your motherboard?  What are its settings?  Is
>the card a plug-and-play type or does it have jumper settings?  What other
>hardware do you have in the system?  Is this card just a parallel port or
>are there other ports of some kind on it?
>
>At 03:47 PM 5/4/99 PDT, you wrote:
> >ok guyz, I'm tryin 2 plug a single PCI I/O card inside my computer.
> >my computer is a PenII and has two slots open.
> >whenever I plug it in, I install the driver, and then it restarts.
> >when it restarts the computer freezes up just before it loads win98.
> >I have changed the settings from ECP, EPP, and Bi-Directional. Always
>does
> >the same. when I unplug the card the computer boots up fine. I exchanged
>the
> >card for a different type of card and I am still comeing up with the same
> >problem.
>
>             Do you want to signoff PCBUILD or just change to
>                     Digest mode - visit our web site:
>                     http://nospin.com/pc/pcbuild.html


_______________________________________________________________
Get Free Email and Do More On The Web. Visit http://www.msn.com

         The PCBUILD web site always needs good submissions.  If
          you would like to contribute to the website, send any
               hardware tech tips or hardware reviews to:
                           [log in to unmask]