Will it start using the "Visit" option in the utilities?  I have a SparQ that
is a parallel and it is very finicky.  If it isn't on when the computer is
turned on the computer doesn't see it until I shut down and turn it on before I
turn the computer on.  If I use the Visit option in the utilities the computer
finds it.

Mark Rode wrote:

> I am upgrading  a 486 DOS PC with a new Pentium / motherboard  running
> WIn98. The 486 had a EIDE hard drive with a SyQuest EZDrive as a slave.
> First I had the hard drive on the primary...a new CD ROM on the secondary
> ...Win98 installed and everything running well. Then I installed the
> SyQuest portable drive.
>
> First I put it as a slave to the Hard drive.
> The Bios sees it ....there is no drive in the SyQuest.....the computer
> starts to boot and Win98 stops loading with a general protection fault.
> please restart your computer. Next I tried running with the Hard drive
> alone on the master and the SyQuest as a Master to the slave CD
> ROM......same general protection fault. Finally I tried the hard drive as a
> Master on primary and the SyQuest as a master on secondary....same problem.
>
> What am I doing wrong.? How am I suppose to set this up in Win98 ??
>
> Thanks
> m
>
>                 Curious about the people moderating your
>                    messages? Visit our staff web site:
>                      http://nospin.com/pc/staff.html

                Curious about the people moderating your
                   messages? Visit our staff web site:
                     http://nospin.com/pc/staff.html