Hello all,
The question I am about to ask may seem pretty elementary to some of you
but I cannot sem to find an answer from any other resource. When mounting
a motherboard, as you know there are several holes for placing the
mounting screws. Around each hole is a solder coating. When should the
little red plastic washers be used and when not. Does the procedure
differ from AT to ATX? I have an ATX Gigabyte GA5AX512 Mobo which I have
mounted using the red plastic washers on all screws with no problems.
Some info on this would be helpful. The manual says nothing about it. I
have also searched "Upgrading and Repairing PC's" and "Tom's Hardware
Guide" Web site with no luck. Thanks.


Paul Sprague
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]

                                  -----
                PCBUILD mailing list -  http://nospin.com
         Bob Wright:[log in to unmask] - Drew Dunn:[log in to unmask]