At 03:44 PM 3/19/1998Holli Van Nest wrote: > >I have a Quantum Pro Drive LPS 400 mg hard drive that I'd like to add >as a secondary hard drive in a system with an IBM hard drive, 540 mg. >The model # on the drive is DALA-3540. I know I need to install >both, configure jumpers and the BIOS. Is there more? > >Also, I have no manuals for either drive. I've looked around on >Quantum's web site to see if I can find the jumper settings for a >master drive, but I couldn't find it. And, truth be told, I really >have very little idea what's involved in setting the jumpers. Holli: Quantum LPS HDDs have a DS drive select jumper on the bottom of the drive, which is set: On for master or solo Off for slave There is also an SP jumper for special applications. Standard IDE drives should work with the DS selection. I'd set the Quantum as a slave (no jumper on the DS block). There are many IBM models which vary in drive selection. Probably, the SOLO drive setting on the IBM is the same as a MASTER drive setting. However, you're best advised to go to the IBM website and consult the on-line materials. Regards, John Chin