You take the top cover off to get to it, then take 2 screws out of the IF unit, tilt that up and if you're lucky, you can get a screw driver down in there to adjust it, trouble is, if you lift the IF unit too much you put strain on wires and can break them and it is very tight, I've had 3 of them and put 1 of those boards in for some one else as well as my 3, if you're not familiar with the in sides of the radio I recommend you have some one else do it honestly. John Miller N1UMJ Owner: J E M Racing need sponsors and crew help to chat with me AOL instant messenger JEMracing3 ----- Original Message ----- From: "Gary Jackson" <[log in to unmask]> To: <[log in to unmask]> Sent: Wednesday, January 15, 2003 4:26 AM Subject: Re: ts440 speech board question > Henry, I never owned the 440 but I know the speech board. I'm not sure where > the board is mounted in the 440 but on one side of the board, the VS-1, > there is a pot to adjust the volume. It just takes a small screwdriver. > Gary > Gary Jackson kk5ge > [log in to unmask] > Phone: 409-962-0353 > ----- Original Message ----- > From: "Henry Brugsch" <[log in to unmask]> > To: <[log in to unmask]> > Sent: Wednesday, January 15, 2003 3:16 AM > Subject: ts440 speech board question > > > Hi, I have a very long-lived ts440s with the speech board on board. It > always had a fairly low level of audio. Now, it's as loud as it can go, > presumably, too loud for comfort. How difficult is it to adjust the audio > level? How do you do it? Thanks > Henry Brugsch > http://listentohear.co.uk > mailto:[log in to unmask] > phone: +441562820090 >