Many of these boards come with the jumper default set to "reset configuration" in place. You need to power up the board one time to do the reset. Next shut off, and switch the jumper so as not to reset, and you should be good to go! Good Luck, Steve Wolfe -----Original Message----- From: PCBUILD - Personal Computer Hardware discussion List [mailto:[log in to unmask]]On Behalf Of Mark Wo Sent: Tuesday, September 19, 2000 8:30 AM To: [log in to unmask] Subject: [PCBUILD] Motherboard with SiS 530 chip Hello All, especially Jun: Thank you for the help. You were right, it did turn out to be a PCChips (M599LMR) MB. I got the manual and printed it, set the jumpers yet I get no video. At least now the power supply, lights,fans and hard drive power up. It has built in AGP graphics. Is there anything that I missed or could try to get the monitor to come on? <The company which carry PC100 brand name is PCChips, you may search their website. www.pcchips.com My last word: PC100 mobo is slow and the onboard video is really bad (almost none of them can run openGL game such as Q3), don't expect to use it as game platform. Jun Qian> <<I don't know much about ATX systems. I put in a 128 MG PC100 Dimm, a cable on for the HD and a 5GB harddrive. everything seems OK but it will not power up. The swith on the power supply doesn't turn the power supply fan on, and the front power button wont start it or anything else either. Any help will be appreciated.>> PCBUILD's List Owner's: Bob Wright<[log in to unmask]> Drew Dunn<[log in to unmask]>