Greetings--
This is a tough one, and I'm just going to take a guess, so take it with the proverbial "grain of salt" (and I'm also assuming that you meant 1-TB, rather than 1-GB for the siz of your new drives) . As I understand your setup, your disks are mirrored in "the hardware". That being the case, I would take one (1) of the (I'm assuming) 1-TB drives and swap it with one of your 500-GB drives letting the hardware mirror the partitions. (You may need to take the additional step of synchronizing the RAID.) This will, of course leave 500-GB (give or take) of unallocated space on the new drive in the array. Once the array was synchronized, I would then repeat the procedure by swapping out the other 500-GB drive for the other new 1-TB drive, and allow the array to be synchronized at the hardware level. If all goes as I think it might you should now have a RAID-1 array with C: drive showing the same amount of space as before, once you open My Computer and check the properties of C:. The next step I would take if this turns out to be the case, would be to right-click My Computer, then left-click Manage. Click on Disk Management under Storage, and use Windows to expand each partition to some portion of the "unallocated space" that should show up. (I'm assuming that each of the 1-TB drives has been formatted.)
Again, as I stated, I've never done this before, but, as I understand RAID, this would seem to be the logical approach. Watch for more posts on this matter, in case others can offer more wisdom.
HTH.
Paul A. Shippert
----- Original Message -----
From: "Ivan Berger" <[log in to unmask]>
To: [log in to unmask]
Sent: Tuesday, November 16, 2010 4:57:37 PM
Subject: [PCSOFT] Switching a RAID array to larger drives
Switching a RAID array to larger drives
I have a Dell workstation with a 500-GB RAID 1 array, using Intel Matrix Manager and running XP Pro. I want to replace the two physical drives in that array with a pair of 1-GB drives. My current drives have three partitions; I'd like the new drives to have the same content in the same partitions, but to enlarge two of the partitions slightly and make the third partition at least 400 GB.
How do I go about this?
PCSOFT's List Owners:
Bob Wright<[log in to unmask]>
Mark Rode<[log in to unmask]>
The NOSPIN Group is now offering Free PC Tech
support at our website:
http://freepctech.com
|
