>At the very beginning of the NT install (the floppy disk portion) you are
>asked if there are any other devices (SCSI, IDE or other) and then prompted
>to insert the NT compatible driver disk.
>
>It is my opinion that the Sanyo was overlooked by you or the operating
>system at this point.

If you go back and read my post you will see that I wrote NT had loaded the
controller for the SB but could not see the actual device. You can see what
controllers are installed in NT by going to Control Panel / SCSI device. A
controller on a SB16 is a standard IDE controller using a normal NT IDE
driver....nothing proprietary here. It is however a slow controller and it
may not work with a high end mode 4 drive.  After installing Service Pack
6a the device...CD ROM appeared and now all is well.

m

                  Visit our website regularly for FAQs,
               articles, how-to's, tech tips and much more
                  http://nospin.com - http://nospin.org