I've had good luck in this situation with a Linux boot disk.
Test Disk may work also.
http://www.cgsecurity.org/wiki/TestDisk
On Mon, Sep 26, 2011 at 5:01 PM, Bruce Lund <[log in to unmask]> wrote:
>
>
> I pulled a Seagate Barracuda 7200.7
> that had been the primary drive on an eMachines T3990.and set it up as a slave
> on the Compaq so I can access data. Jumper on Seagate is set to cable select and attached it to middle,
> grey connector.
>
>
>
> Upon boot up, Windows (XP Pro) scanned
> disk, found lots of bad sectors, or whatever, and required reboot upon
> completion.
>
>
>
>
> Tried to open what is now identified as E
> drive, got message “Windows Explorer has encountered a problem and needs to
> close.” Oh, and they are sorry for the inconvenience. Clicking on Debug and Dr Watson
> also encountered a problem. And they are sorry for the inconvenience.
> Subsequent attempt got message disk is not formatted, and asking if I want to format it. Well, if I could format it without losing data, I would, but I don't think that's an option, is it?
> As it turns out, just clicking on My Computer gets an error message, although not right away.
> I have tried Seagate Disc Wizard and it shows the drive as a primary slave. (Compaq's drive is showing up as primary master.) If I try to add new disk, it wants to delete partitions (There is one where operating system is.) However, it says the operation is only possible if destination had disc is empty. Again, I want to access the data on this drive, not eliminate it.
>
> So, how do I get Compaq to recognize the slave drive so I can access data?
> Thanks!
> Bruce
>
>
>
>
>
> PCBUILD maintains hundreds of useful files for download
> visit our download web page at:
> http://freepctech.com/downloads.shtml
>
PCBUILD's List Owners:
Bob Wright<[log in to unmask]>
Mark Rode<[log in to unmask]>
|
