On Mon, 29 Jun 1998 23:39:39 -0700 Mark Rode <[log in to unmask]> writes:
>I have  a Seagate EIDE Mode 4 850 meg drive. It is partitioned as one
>extended with two equal logical drives.
snip
>BIOS sees the drive ,posts and boots but I can not access the drive. I
>receive a Invalid drive specification message.
snip
>
>As soon as I run the Seagate on another board every thing is fine!
>
>Anybody have any ideas?

      Can I assume the drive is LBA  -  AND in the  various system(s)
BIOS?
      Could be you found one of those different "flavors" of LBA
       that  will only run a drive on a system it was set up on...
       I thought this happened  more on software driven controller cards.
              Rick Glazier

_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]