[log in to unmask] wrote:
> In a message dated 01/17/2000 11:21:49 PM Eastern Standard Time,
> [log in to unmask] writes:
>
>
>  Thanks again to all who helped.
>  Brad Loomis
>  Los Angeles, CA >>
>
> Hi,
>   I see from your post you are setting one of the drives to ID 0 (zero). As I
> recall, ID 0 is reserved for the SCSI controller itself, and is not supposed
> to be used for any other device. You might try resetting ID #'s on the
> drives, so as not to use ID 0, and see if that helps.

The controller is usually SCSI ID 7, SCSI ID 0 is typically the first SCSI
(boot) drive.


--
Russ Poffenberger               Engineering Specialist
Schlumberger Technologies ATE   DOMAIN: [log in to unmask]
1601 Technology Drive
San Jose, Ca. 95110             Voice: (408)437-5254  FAX: (408)437-5246

                         PCBUILD's List Owner's:
                      Bob Wright<[log in to unmask]>
                       Drew Dunn<[log in to unmask]>