Is it possible the offsets were changed around? Or, maybe the cross band? so 
it's transmitting on another band, which can be changed by pushing the 
function button, and the band button. Low beep is normal, high beep is tx on 
the other band from where you're listening. Off set is function then rev, 
which is 2 over from the band button. Low beep is simplex, I forget the 
order of the others but cycling through will likely get what you want. 
Otherwise I wonder if there's something done in the menu.
----- Original Message ----- 
From: "Jim Kutsch" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, August 08, 2007 8:20 PM
Subject: TMG707A Stopped Transmitting


> CQ TMG707A Experts,
> I'm reaching out to all of you Kenwood TMG707A operators for some quick =
> help.  I've been digging through the manual but finding no answer.
>
> My fairly new Kenwood TMG707A stopped transmitting.  I'm using =
> preprogrammed channels that have worked fine for months.  When I push =
> the PTT, the fan starts, the receiver cuts out, but there's no output at =
> all.  I've verified nothing out by monitoring with another 2M rig. =20
>
> This problem started after several front panel buttons were pressed =
> randomly.  It's almost like a transmit lock was activated but if so, I'm =
> surprised that the fan still starts up.  I tried the directions for =
> keypad lock/unlock but no success.  Any ideas what happened and how to =
> recover?  I could do a reset to factory defaults but I hate to lose all =
> of my frequency and PL programming.
>
> Thanks
> 73,
> Jim, KY2D