Hello Tom,

I hope you get the remaining 6 counties tomorrow!

73,
Jim
WA5VYL


-----Original Message----- 
From: Tom Behler
Sent: Saturday, October 10, 2015 11:12 PM
To: [log in to unmask]
Subject: Re: TS590 question

Maybe so, Steve.

I guess it just goes to show how long it has been since I've used my TS590
here at the home QTH.

Have made 212 contacts so far in the Pennsylvania QSO Party, and have 61 out
of the 67 counties!

Will see how tomorrow goes.

Tom Behler: KB8TYJ


-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Steve
Sent: Saturday, October 10, 2015 12:29 PM
To: [log in to unmask]
Subject: Re: TS590 question

I think it is normal Tom, remember you are changing the frequency when =
going from LSB to USB because of the VFO offset in the way the frequency =
is inserted with the local oscillator.


----- Original Message -----=20
From: Tom Behler=20
To: [log in to unmask]
Sent: Saturday, October 10, 2015 11:46 AM
Subject: TS590 question


Hello, all.

=20

I am getting ready to do the Pennsylvania QSO Party contest, and have
noticed an interesting problem with my TS590.

=20

It seems that whenever I switch modes, say from LSB to USB, or from SSB = to
CW, the VGS1 announces my current operating frequency.

=20

Typically, I remember this only happening if I press the enter key, in =
line with the way I have the rig set up.

=20

I don't think this is going to get in the way of my contest operating, = but
am curious if this is normal behavior, or whether I have done something = to
make this happen.

=20

It's been a while since I've used my TS590 here at the Home QTH, so =
perhaps I've got something mis-adjusted.

=20

Tom Behler: KB8TYJ