I tried turning down the volume and pressing the moni key and no luck.
I tried turning the squelch off and no go.
I cannot change the status of the tone using the & 7 key.  All I get is a 
high beep when I press it over and over again.
----- Original Message ----- 
From: "John Miller" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, May 21, 2006 10:09 PM
Subject: Re: Storing a Frequency in TH-F6A Memory


> you might have got the squelch too high, the tones on for receive too, or,
> on the b band, you could have the volume for the B band too low, I found 
> if
> you turn the volume all the way down, and hit moni, as I recall, it will
> bring the volume back to match the other band while you hold the moni 
> button
> so you might check that too. My moni button no longer works most of the
> time, but when it does, I seem to recall that was the case when I played
> around with it.
> ----- Original Message ----- 
> From: "Pat Byrne" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Sunday, May 21, 2006 7:43 PM
> Subject: Re: Storing a Frequency in TH-F6A Memory
>
>
>> You might have gotten the receiver in the "other" tone decode mode;
>> press the 7 key until you get the low beep and then you're sure to be
>> in the "carrier" access mode.
>> Pat, K9JAU At 05:26 PM 5/21/2006, you wrote:
>>>Here's another thing interesting about this problem.  On the b band, I
>>>have
>>>to hold the mono button to hear anything.  I'm not sure what to do with
>>>the
>>>radio now.  I may have to get sighted help.
>
>
>