all that does is automatically adjust the screw dirvers that support the 
automatic adjustment via the radio, it's just an interface for them as 
apposed to the manual adjusting one. It's not actually a Tuner per say, just 
the interface for the screwdriver.
----- Original Message ----- 
From: "T Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, May 25, 2006 1:32 PM
Subject: Fw: Emailing: tubro_tuner


> Hi, all.
>
> I don't know if this will come through the list, but does anyone know 
> about
> this new auto-tuner?  I'm curious on how it works in comparison to, say, 
> one
> of the common LDG out-board auto-tuners, such as the AT11MP or the Z100.
>
> I am curious also as to why it is marketed to work especially well with
> "screw-driver-type" mobile antennas.
>
> This may be useful to my camper trailer HF set-up, but I don't want to 
> spend
> the bucks on it until I know more.
>
> I also was under the impression that you couldn't use an auto-tuner with a
> screw-driver-type antenna since the ant is, esentially, a tuner in and of
> itself.
>
> Thanks, and best 73 from tom Behler: KB8TYJ
>
> ----- Original Message ----- 
> From: "Dale Colby" <[log in to unmask]>
> To: "Tom Behler" <[log in to unmask]>
> Sent: Wednesday, May 24, 2006 11:46 AM
> Subject: Emailing: tubro_tuner
>
>
> tubro tuner
> N2VZ Enterprises
>
> Turbo Tuner TM
>
>  Fully automatic screwdriver antenna controller for:
>
>  Icom , Kenwood, & Yeasu radios
>
>
>
>
>
>  a.. Plug and Play with your Kenwood or Icom radio.
>
>  b.. The controller will find the lowest SWR for a given frequency.
>
>  c.. Fully automatic adjustment of the screwdriver antenna to the current
> operating frequency.
>
>  d.. No calibration required Just plug it in and tune!
>
>  e.. Tuning is initiated with the tune control located on the radio.
>
>  f.. All tuning is performed with 10 watts or less.
>
>  g.. Firmware is upgradeable via a PC computer (no chip swapping).
>
>  h.. The controller is RFI filtered and is RF bullet proof to full legal
> limit.
>
>  i.. Current rating up to 1 amp for driving large screwdriver antennas.
>
>  j.. Works with most Icom HF and marine radios.
>
>  k.. Works with Kenwood TS-480, TS-2000.
>
>  l.. Works with Yaesu FT-897, 857.  Works on 160 & 75 Meters does not use
> ATAS circuitry.
>
>  m.. Park function that will automatically lower the antenna to its
> shortest position.
>
>  n.. Fully plug and play with Tarheel antennas and High Sierra and Hi-Q.
>
>
>
>                 Download the Icom IC-706 Manual
>
>                 Download the Kenwood TS- 480 Manual
>
>                 Download the Kenwood TS-2000 Manual
>
>                Download the Yaesu FT-857/897 Manual
>
>
>
>  a.. 30 Day satisfaction guarantee which allows you return it if not
> completely satisfied.
>
>  b.. Life Time no matter what warranty for parts & labor. Unless the case
> is charred or melted and maybe even then if you have a good story.
>
>
>
>                     Read our reviews on eHam.net
>
>