You can find manual and other info at tigertronics.com
While I've never used it, I have heard that their telephone support is
good.
Are you sure you installed the jumper block the right way? When you
connected the usb to the pc, did the drivers install automaticly?
73, Steve KW3A
On 6/5/2013 8:52 AM, DAN REID wrote:
> Is there a manual online or a spot I can go to read more info? I'm not =
> able to get it to work as of yet other than the lights do come on.
> Is there info on the I can work this thing website?
> I understand that it depends on the program being used, but the initial =
> setting up between the rig and the unit would be helpful.
> thanks,
> dan (kb6unc)
> ----- Original Message -----=20
> From: Gerry Learry<mailto:[log in to unmask]>=20
> To: =
> [log in to unmask]<mailto:[log in to unmask]>=20
> Sent: Wednesday, June 05, 2013 4:18 AM
> Subject: Re: signalink
>
>
> What is a signalink?
> ----- Original Message -----=20
> From: "Steve Forst" <[log in to unmask]<mailto:[log in to unmask]>>
> To: =
> <[log in to unmask]<mailto:[log in to unmask]>>
> Sent: Tuesday, June 04, 2013 5:08 PM
> Subject: Re: signalink
>
>
> > There are 4 allen screws on the front panel and 4 on the rear. You =
> want
> > to remove the 4 from the front., then grab the front panel and pull =
> it
> > out . The front panel with knobs attached, and the circuit board =
> will
> > come out as one unit. If you remove the rear screws, all you do is =
> get
> > the rear panel off and the board remains inside the box.
> >
> > When you get the board out, lay it on a book or something so the
> > attached front panel hangs over the edge. If that doesn't make
> > sense, it will when you are holding the front panel/board assembly =
> in
> > your hand.
> >
> > There will be an allen key included in the package.
> > 73, Steve KW3A
> >
> > On 6/4/2013 6:38 PM, DAN REID wrote:
> >> DXE Engineering informs me that I need to remove four screws to =
> install=20
> >> =3D
> >> the plug and play chip. Are these screws in the front or back of =
> the =3D
> >> unit?
> >> Thanks,
> >> dan (kb6unc)
> >>
> >>
> >>=20
>
>
>
|
