Yes thanks, I plugged in the mike from my TMV71a and it did just that. It worked but the keypad didn't work. What are the differences between those two mikes you mentioned?
Frank

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]] On Behalf Of [log in to unmask]
Sent: Friday, October 23, 2015 2:25 PM
To: [log in to unmask]
Subject: Re: Identifying a Kenwood dual band radio

Hi,
I must differ, the mike for the TMV71A will work on the TM-V7A, butPF buttons will not work.  The correct mikes for the TM-V7A are the MC53DM andd the MC58DM only.  73. Gary KB2YAA

-----Original Message-----
From: Don Breda
Sent: Friday, October 23, 2015 6:35 AM
To: [log in to unmask]
Subject: Re: Identifying a Kenwood dual band radio

The mic for that radio is the same as the one for the tm-v71a which I believe you have.

Don



On 22-Oct-15 6:22 PM, Frank Ventura wrote:
> Hi all, I need a little help identifying a dual band (2m/440) radio. 
> It loo= ks similar to a Kenwood TMG707 but in the bottom left there 
> are two volume/= squelch knobs just like a new TMV71a. On the left 
> there are three button Ca= ll, VFO and MR and the tuning knowb is 
> beneath that. To the right of the tu= ning know there are four round 
> buttons. To the right of those buttons there=
>   are the two volume/squelch knobs and a small button between them. 
> Above on=
>   the right side is the power button, PM and menus buttons. The radio 
> works = fine but I would like to nail down an exaxt model so that I 
> can download a = manual.
>
> Thanks
>
> Frank