Sender: |
|
Date: |
Tue, 25 May 1999 13:36:28 -0400 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
7bit |
Content-Type: |
text/plain; charset="iso-8859-1" |
Organization: |
Micro Solutions Consulting |
From: |
|
Parts/Attachments: |
|
|
I've seen this same problem but it is usually solved by FDISK.
In my experience, older systems have problems with drivers for peripheral
equipment like CD-ROMs and printers, but I haven't seen a system that
refuses to load Win98 -- if properly prepared.
Just make sure you are using a Windows 98 boot disk (DOS 7.0), then run
A:\FDISK and delete all partitions. REboot the PC and create a new
partition(s), and format it (them). Now reboot again and install Windows
98. This is what works for me.
Jim Meagher
=====
Micro Solutions Consulting Member of The HTML Writers Guild
http://www.ezy.net/~microsol International Webmasters Association
410-543-8996 MS Site Builder Network - Level 2 member
=====
----- Original Message -----
From: Twin*.*Star <[log in to unmask]>
>
> One problem with Win98 is that it will not install on all machines
> especially those made before its existence.
>
> -----Original Message-----
>
> >Here's the Problem:
> >I'm trying to install Win 98 on a new WD 13.something gig HD. The
> >installation goes fine until what I beleive to be the last
> >re-boot..whereupon the cmos screen shows "completed updating files,
> >continuing to load windows" and it stays right there.
> >it does not go any further. I've tried reloading it , with fresh
> >re-formatting several times,
PCBUILD's List Owner's:
Bob Wright<[log in to unmask]>
Drew Dunn<[log in to unmask]>
|
|
|