Check the FIC Website at http://www.fica.com. There is an addendum to the
Manual there, that gives the proper jumper settings for this board. If you
still have trouble with the settings, Let me know and I will dig up the
newer settings and send them to you...

This board is indeed capable of 100 mhz bus speed, and unsupported to
112mhz. I think there is even an update out now for 125mhz.

If the Ram you are using is not PC100 Compliant it may not work, but should
not be a problem.

Steve Wolfe.....


> I am trying to build a system with the FIC v503+ mb and the AMD K6-2-300
> CPU.
> I am having trouble setting the jumpers. I seems that the manual doc no.
> 16409, Rev. A3, dated 7, 1998 Part no. 25-10865-03, has wrong or
> conflicting
> information.
> When looking at the mb the diagram showing the jumpers for the SDRAM & the
> FREQ, do not match with that shown in the manual.
> Does any one have any information which one is correct? the manual or the
> mb?
> Does this board & CPU support 100mhz bus speeds?
> How do I achieve the settings for 3x100 to get it to run at 300mhz?
> I can get it to run at 300 mhz using 66mhz and FREQ of 4.5, but
> not 100 mhz
> and 3.3 FREQ. As a matter of fact there is no 3.3 FREQ setting
> shown in the
> manual (on pg.18)
> I am using a "Generic" 64mb SDRAM memory chip with this set-up. Does this
> make a difference?

                                  -----
                PCBUILD mailing list -  http://nospin.com
         Bob Wright:[log in to unmask] - Drew Dunn:[log in to unmask]