Hello and I sure hope someone can help me with this ram.
I have a Microstar MS-6117 motherboard and bought a 64MB
EDO/ECC 8X72 168pin Unbuffered DIMM. The motherboard
manual says that it supports EDO and ECC. When I tried
to install it, one of the cutouts on the bottom of the DIMM
didn't match up with the (key?) on the motherboard DIMM
slot....it was about 1/16" off. I took another 168pin DIMM
and held them up to each other and they didn't match up.
Are there different sizes? of DIMM's or was this one just
cut wrong? Any help you can give me with this will be
most appreciated.
Thanks
Dan Duffy
-----
PCBUILD mailing list - http://nospin.com
Bob Wright:[log in to unmask] - Drew Dunn:[log in to unmask]