Everick,

I have the same setup, but my book is dated 5, 1998 and the
part number is a -02 not -03.

On page 18 & 19 it lists two settings for my K6-2/300 at
66 x 4.5 and 100 x 3.

For 100 x 3 the jumper settings are shown as:
FREQ 1  1-2          CLK 1  1-2
FREQ 2  2-3          CLK 2  1-2
FREQ 3  1-2          CLK 3  2-3


Jim Meagher
=====
Micro Solutions Consulting     Member of The HTML Writers Guild
http://www.ezy.net/~microsol   International Webmasters Association
=====

> -----Original Message-----
> From: PCBUILD - Personal Computer Hardware discussion List
> [mailto:[log in to unmask]]On Behalf Of Everick Holder
> Sent: Tuesday, October 06, 1998 8:39 PM
> To: [log in to unmask]
> Subject: [PCBUILD] FIC V503+ & AMD K6-2-300 CPU
>
>
> I am trying to build a system with the FIC v503+ mb and the AMD K6-2-300
> CPU.
> I am having trouble setting the jumpers. I seems that the manual doc no.
> 16409, Rev. A3, dated 7, 1998 Part no. 25-10865-03, has wrong or
> conflicting
> information.
> When looking at the mb the diagram showing the jumpers for the SDRAM & the
> FREQ, do not match with that shown in the manual.
> Does any one have any information which one is correct? the manual or the
> mb?
> Does this board & CPU support 100mhz bus speeds?
> How do I achieve the settings for 3x100 to get it to run at 300mhz?
> I can get it to run at 300 mhz using 66mhz and FREQ of 4.5, but
> not 100 mhz
> and 3.3 FREQ. As a matter of fact there is no 3.3 FREQ setting
> shown in the
> manual (on pg.18)
> I am using a "Generic" 64mb SDRAM memory chip with this set-up. Does this
> make a difference?
>
> Any help would be gratefully appreciated.
>
> Everick Holder.
>
>                                   -----
>                 PCBUILD mailing list -  http://nospin.com
>          Bob Wright:[log in to unmask] - Drew Dunn:[log in to unmask]
>

                                  -----
                PCBUILD mailing list -  http://nospin.com
         Bob Wright:[log in to unmask] - Drew Dunn:[log in to unmask]