Dharam Bhardwaj wrote:

> It is not obvious to me how to open this IBM Aptiva tower case. Can
> someone direct me?
> The only 'screws' I can see are on the top just under the 'handle'. These
> don't seem to 'release' the front or back. I can't seem to locate any
> 'latch' or similar tab. The tower case I am referring to, has a plastic
> 'lid' which slides up or down to cover the front of the drives.
> Regards,
> Dharam
>
> --
>   Dharam Bhardwaj                    |
>   E-mail:    [log in to unmask]     |
>   Fax:       403-282-8969            |

The base, back, sides, and top are all one unit.  Remove the screws below the

"handle" then you can pull the front panel and the  "guts" will slide out the
front
end of the case.


--
Jim Meagher
=====
Micro Solutions Consulting        Member of The HTML Writers Guild
http://www.ezy.net/~microsol     International Webmasters Association
410-543-8996                MS Site Builder Network - Level 2 member
=====

            PCBUILD maintains many useful files for download
              on our web site - visit our download page at:
                     http://nospin.com/pc/files.html