Hi.
SB=SoundBlaster.
I had the CD on the IDE of an SB, as tertiary (1E8+). First NT4's
didn't support the CD here, so I had only CD through the lan. To my
surprise, NT4 SP3 supported CD on that IDE. But COM3 stopped working,
and I lost the modem: NT4 had found an incompatibility related to
port 3EE. So I changed IDE to quaternary, and had CD and modem.
None of this applies to you; I only wanted to point out
that SP3 has more solutions on IDE ports. I would suggest to check
IDE ports (on Control Panel SCSI, strangely), or inspect the boot
history (sorry, in spanish version, the "visor de sucesos").
>
> Hi,
>
> This is not really a multi-boot problem, I guess, but a hardware
> detection problem. I mentioned the multi-boot just to round out
> the description.
>
> I have SP-3 installed. Always have, and always reinstall it after
> any change. No joy. Not sure what you mean by SB below. Can
> you clarify? My jukebox is on the secondary IDE, I believe. At
> any rate, SP-3 is not the answer. :(
>
> Lance
>
> On Mon, 30 Mar 1998 09:01:19 +0000, [log in to unmask] wrote:
>
> > Hi.
> > I ran into a multi boot problem with NT4. For it too work
> > completely, I had SP3 installed, and since I was using the CD at
> > the IDE of a SB, I changed this last to quaternary (168+, 36E and
> > IRQ10); there are reasons to do so. If your jukebox is at an
> > IDE not primary/secondary, you can go this way, or at least try
> > SP3, which I think is more debugged.
> >
> > >
> > > I run a quad-boot box. P5-120 with the Sanyo
> > > 3-cdrom jukebox.
> > >
> > > When I come out of NT4.0, I get an "ATA Disk Change --
> > > press any key to continue" message. This throws me
> > > into my BIOS setup (Mr. Bios), and the ATA Disk shows
> > > Lance
> >
>
************************************
Javier Vizcaino. Ability Electronics. [log in to unmask]
Starting point: (-1)^(-1) = -1
Applying logarithms: (-1)*ln(-1) = ln(-1)
Since ln(-1) <> 0, dividing: -1 = 1 (ln(-1) is complex, but exists)
|
