In a message dated 4/6/99 8:51:57 AM, [log in to unmask] writes:
>Could you outline a typical treatment with specific materials, methods and
proceedures?>
Power wire brush or power-wash to remove loose coatings.
Prime rusted areas and bitumen patches with special primers.
Make repairs to substrate where applicable.
Apply approx. 1-1/2 gallons per square of basecoat & imbed poyester
reinforcing followed by same coverage overcoat.
When dry, apply tinted final coat.
This basic spec is amended to fit particular situations. The polyester can
be omitted when not required, the material formulation can be adjusted by
the manufacturer (and, to a lesser extent, in the field), aggregate can be
added to the basecoat to create a filler/etc.
Contact [log in to unmask]
Best regards, John. I have enjoyed your work for years.
John Mascaro