i have an even older Heil mike than the Goldline and it, also has a
four prong male connector in the base of the mike. Somewhere around
the shack I have an old Electrovoice 664 mike and I believe it has
the three prong XL connector. Perhaps it is a bit larger in diameter
than the Heil, but that is just a memory. I think that mike is
buried in a carton and not easy to get to. Thanks.
pat, K9JAUAt 03:59 PM 8/26/2015, you wrote:
>OK, interesting. So at least in the case of the Goldline and it's
>cable, circa 2001, it was a 4 pin setup. I would just confirm that
>if mixing brands, that mic and cable are the same.
>
>73, Steve KW3A
>
>On 8/26/2015 4:45 PM, Colin McDonald wrote:
> > there are 4 pin xlr type, though they are not common...the common type is
> > the 3pin variety.
> > The 4 pin may be called something else, or just xlr...the 3pin
> xlr connecter
> > has been out for many decades though so nothing has changed, and the 4 pin
> > has been out since at least the 60's as I had an old guitar amp that used a
> > 4pin xlr to connect the head to the cabinet...and now that I
> think about it,
> > they reversed the standard configuration and the cabinet had the male
> > connecter for input instead of the standard opposite of that.
> >
> > 73
> > Colin, V A6BKX
> >
> >
> > -----Original Message-----
> > From: Steve Forst
> > Sent: Wednesday, August 26, 2015 2:22 PM
> > To: [log in to unmask]
> > Subject: Re: Heil CC1-XLR
> >
> > Mike,
> >
> > I'm no audio guy, and have little experience with XLR connectors.
> > However, in 2001 when I got my Goldline mic as a free promotion, it
> > came with a long cable with XLR female on one end to connect to the mic
> > and 8 pin round for the radio end with the 1/4 jack for ptt.
> >
> > The XLR connectors were 4 pin and didn't match up with anything else I
> > had in the shack. Don't know if this is a different standard, an
> > oddball, or something peculiar to Heil. Again, I don't know much about
> > this stuff, and it was 15 years ago. Maybe different today.
> > If you plan on mixing the Heil cable with another mic, I would
> > confirm that things will match up before spending the money.
> >
> > 73, Steve KW3A
> > On 8/26/2015 3:57 PM, Colin McDonald wrote:
> >> if the connecter is on the microphone, it'll be a 3pin male...in the XLR
> >> world, audio signal output is always XLR male, and input is always Female.
> >>
> >> 73
> >> Colin, V A6BKX
> >>
> >>
> >> -----Original Message-----
> >> From: Michael Ryan
> >> Sent: Wednesday, August 26, 2015 1:26 PM
> >> To: [log in to unmask]
> >> Subject: Heil CC1-XLR
> >>
> >> Hi all:
> >>
> >> Is the 3 pin XLR connector on the CC1 a male or female? The mics I'm
> >> looking
> >> at are all 3 pin XLR male.
> >>
> >> TNX and 73:
> >> Mike DE VO1AX
> >>
|