Subject: | |
From: | |
Reply To: | |
Date: | Tue, 26 May 2015 16:07:47 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Kent:
I copied this from the operators' manual for the TMV-71A. I hope it helps.
STORING ODD-SPLIT REPEATER FREQUENCIES
Some repeaters use a receive and transmit frequency pair with a non-standard
offset. To access those repeaters, store two separate frequencies in a
memory
channel. You can then operate on those repeaters without changing the offset
frequency you stored in the menu.
1 Set up a simplex channel by following steps 1 to 6 of "STORING SIMPLEX
AND STANDARD REPEATER FREQUENCIES", above.
2 Press [VFO] to enter VFO mode.
3 Rotate the Tuning control to select your desired transmit frequency.
· Additionally, you can press the microphone [UP]/[DWN] keys to select a
frequency.
4 Set up any additional data desired for the transmit frequency.
· Tone ON/OFF, Tone frequency, CTCSS ON/OFF, CTCSS frequency, DCS ON/OFF,
DCS code, etc.
5 Press [F].
· A memory channel number appears.
6 Rotate the Tuning control to select your desired channel number.
· Additionally, you can press the microphone [UP]/[DWN] keys to select a
channel.
7 Press [PTT], [MR] to store the data in the selected Memory channel.
73,
Gale
[log in to unmask]
----- Original Message -----
From: "Kent Plemmons" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Tuesday, May 26, 2015 10:49 AM
Subject: TM-V71A setting offset freq
Hi List,
Can anyone tell me how to set an offset frequency of 0.990MHz on my TM-V71A?
My receive freq is 146.775 and my transmit freq needs to be 147.765.
When I go to menu #400 to select an offset value, it appears that all of the
available offset values are in multiples of 0.05MHz.
There must be another way to do this using the radio but I haven't run
across the solution yet.
Thanks
Kent Plemmons
Clyde NC KK4FFF
|
|
|