I agree with Mike's ideas.
However, using a four pound club hammer is usually sufficient.
Most people put too much force into the rod with a heavy hammer which may
bend it.
If you let the four pounder drop onto the top of the rod and let it bounce,
the rod usually goes in more easily.
Stakes for a marquis, and power anchors are different though!
73
David W Wood
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Mike Duke, K5XU
Sent: Tuesday, May 26, 2015 11:35 AM
To: [log in to unmask]
Subject: Installing Ground Rods
Mark, here is one way that I have seen it done.
Dig a small hole, at least a foot deep, and fill it with water.
After the ground softens, stand the rod in the hole, and push it down
as far as you can. Initially, that will not be very far.
Now, pull the rod out, add more water to the spot where you pushed it
down, and push the rod down again.
Keep doing this until you have gone as far down as you can. Then, still
keeping things as wet as possible, bring out the sledge hammer.
Depending on your soil conditions, I have seen people push an 8 foot
rod at least 5 feet into the ground that way.
--
Mike Duke, K5XU
|