Jim,
I'm sorry I misread your message. I'm getting goofy in my old age. Of
course you weren't talking about the Tune button, but the one to the
left of it, the Send button. I know that in CW mode it doesn't TX if
a key is plugged in to the rear panel. The RX is shut off, but no
power goes out. If no key attached, it will TX in CW mode with the
send button. May behave the same with a paddle attached, but I'm not
sure.
Sorry, Steve KW3A
On 2/5/2015 3:51 PM, Steve Forst wrote:
> Not sure I follow you on this one. The button you describe is the
> tuner button to activate the auto tuner. It will send "SWR" in cw if a
> match can't be found.
>
> I think what Mike was discussing was the ability to have the PF key
> set up to announce the actual SWR reading. He seems to not be able to
> do this in SSB for some reason.
>
> Not sure how you have your PF keys set, but they can be set to announce
> s-meter, power out, alc, swr, and comp settings.
>
>
> Of course I may have misunderstood Mike's original message in the first
> place.
>
> 73, Steve KW3A
>
> On 2/5/2015 2:25 PM, Jim Gammon wrote:
>> Seems like you would get SWR readings if you push the lower left
>> button in the top left group of eight buttons, no matter what
>> mode you are in. Jim WA6EKS
>>
>> ----- Original Message -----
>> From: Steve Forst <[log in to unmask]
>> To: [log in to unmask]
>> Date sent: Thu, 5 Feb 2015 07:56:57 -0500
>> Subject: Re: Discovery after upgrading the Ts590:
>>
>> Mike,
>>
>> Although I did the recent update at the high rate via the USB
>> connection, most of the stuff I run is via the serial port at
>> 9600 and
>> no problems.
>>
>> The SWR will read in SSB. Be sure you are putting some solid
>> audio
>> into the mic. Of course it is just as easy to check SWR in CW
>> or FSK mode.
>>
>> Toggle the meter button until it says "R" to read SWR.
>>
>> 73, Steve KW3A
>>
>> On 2/5/2015 7:32 AM, Mike wrote:
>> The SWR butten talks only in the CW position.
>> The upgrade went fairly easy. I had to change my baud rate, it
>> didn't
>> list 9600 so I changed it, then I changed it back.
>> I do have a question, Would it be better if I used a faster baud
>> rate?
>> Thanks.
>> Mike
>> KD2CDU
>>
>>
>>
>
>
>
|
