Great! Thanks!

Don


On 2/5/2015 2:50 PM, Bob Tinney wrote:
> Don,
>
> Yes, I did put the rubber cushions on the board.  The VGS1 will plug in
> only one way.
>
> Bob, K8LR, [log in to unmask]
>
> On 2/5/2015 11:39 AM, Don Breda wrote:
>> Thanks Bob.
>>
>> Just curious, what about polarity? Does it only fit in one way?
>>
>> Did you put the rubbre cushions on it as the instructions say in the manual?
>>
>> Thanks.
>>
>> Don
>>
>>
>> On 2/4/2015 4:38 PM, Bob Tinney wrote:
>>> Don,
>>>
>>> The VGS1 is easy to install.  It takes longer to take out all of the
>>> screws and put them back than it takes to install the board. Just remove
>>> the bottom cover and look for a square metal shield that's held in by
>>> three or four screws, remove the shield and the socket that the VGS1
>>> plugs in is right where the shield was.
>>>
>>> Bob, K8LR, [log in to unmask]
>>>