I am pushing the tune button until it starts tuning.
I am also checking in CW mode.
It used to show 98 watts with the tuner in line.
The only thing I have hooked up to my power supply is the radio and the TW1.
I will check the readings with a dummy load, and get a set of eyeballs to 
tell me what the meters on the power supply read.
Thanks, and 7 3.

-----Original Message----- 
From: John Miller
Sent: Thursday, September 11, 2014 12:07 PM
To: [log in to unmask]
Subject: Re: TS-2000 not putting out full power.

Are you actually hitting the tuner button and holding it for a half second
or so so it's tuning or just turning it on? If it's just on but not tuned
for that antenna and never has been tuned for that antenna it may not be
tuned for that antenna and the TW-1 or any external meter is only going to
see what the antenna is, it will not see what the internal tuner is doing.
IF your SWR is that good though I wouldn't worry about turning the tuner on
at all. If it's all tuned and still down on power, I'd say maybe you have
bad power connections, make sure the power supply is up to voltage, make
sure your power is set to full. Also, what mode are you checking this in?
It's almost impossible to get an accurate reading on SSB with the TW-1,
you'd have to go to AM, CW, what ever and on AM you should only see 25
watts. You'd need FM or CW to see full power out.
----- Original Message ----- 
From: "Rick" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, September 11, 2014 11:11 AM
Subject: TS-2000 not putting out full power.


> Hi list.
>
> According to my TW1 my TS-2000 is only putting out 55 watts on all the HF
> bands.
>
> It is also showing swr less than 1.5 average on all the bands.
>
> I have the internal tuner turned off, with it on it shows 52 watts.
>
> Is there something that could be causing low output power, or do I need to
> send my radio for repairs?
>
> Thanks in advance for any help, and 7 3.