BLIND-HAMS Archives

For blind ham radio operators

BLIND-HAMS@LISTSERV.ICORS.ORG

Options: Use Forum View

Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Howard Kaufman <[log in to unmask]>
Reply To:
For blind ham radio operators <[log in to unmask]>
Date:
Thu, 13 Mar 2014 14:16:55 -0500
Content-Type:
text/plain
Parts/Attachments:
text/plain (105 lines)
You can change the side of the signal you are listening to by pressing and 
holding the mode menu button.
This way the cw tones and the ssb audio go the same way.
The nice two features that the 480 have for cw, is
1.  Tap the key and the mode changes to cw.  2.  The offset is automatically 
set to your side tone offset.
I think menus 32 and 33 but I am not sure.
I was wrong.
From the ts480 menus section.

I suggest manually adjusting the weight ratio if you send over 25 WPM.
Try 3.1.

32 Interval time for #31 Interval time can be adjusted up to a maximum of 60 
seconds.

33 Keying priority over playback Without switching off the repeat

32

playback for messages, you can start

keying.

34 CW RX pitch / TX sidetone

frequency

Select RX pitch frequency between

400Hz and 1000Hz. At the same time,

sidetone frequency changes with the

pitch frequency. This can be used to

zero in on a target signal by matching

the sidetone frequency with the RX

beat.

35 CW keying weight ratio Change the dot/dash weight ratio. This is usually 
set to AUTO.

36 Reverse CW keying auto

weight ratio

You can change the AUTO setting for

#35.

37 Bug key function Manual TX can be enabled for dashes only.

38 Swap dot & dash paddle

position

Swap the paddle position to suit either

right-handed or left-handed use.

39 Auto CW TX in SSB mode Automatically switch mode to CW transmission by 
simply operating the paddle.

CW

40 Define CW tune frequency Useful if used in combination with #39,

as there is no need to operate the dial

to zero in on a target.

----- Original Message ----- 
From: "Jim Gammon" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, March 13, 2014 1:39 PM
Subject: Matching CW to sideband?


> Howard, how did you set the CW to match the sideband? I also have
> a 480 and am interested in that feature.  73, Jim WA6EKS
>
> ----- Original Message -----
> From: Howard Kaufman <[log in to unmask]
> To: [log in to unmask]
> Date sent: Thu, 13 Mar 2014 05:01:04 -0500
> Subject: Re: Auto Zero Beat With Ts590
>
> I set the cw on the 480, to match the side band used on the same
> band.  That
> way when I tune across the band, things are similar.
>
>
> ---
> This email is free from viruses and malware because avast!
> Antivirus protection is active.
> http://www.avast.com 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com

ATOM RSS1 RSS2