Thank you Ed and Howard#3 and again to steve. I got it. One goes on top of
the synthesizer and one on the bottom.
Thank you,
Kent
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Ed Malmgren
Sent: Monday, November 18, 2013 10:15 PM
To: [log in to unmask]
Subject: Re: installing VGS1 on TS-590
Kent, you use two of the pads. If there still in the pack, it's the second
and the forth down from the large one. The large one say, no.1 and then
down you would use 2 and 4 and they both go on top under the cover that you
must take off with the four screws. That's all I can say with my X Y L's
discription hi hi . G L 73
Ed K7UC
--------------------------------------------------
From: "Steve Forst" <[log in to unmask]>
Sent: Monday, November 18, 2013 7:52 PM
To: <[log in to unmask]>
Subject: Re: installing VGS1 on TS-590
> The manual does say to use 2 foam pads and the other 3 are not used,
> but the description isn't very clear on the placement. It does say to
> attach them to the vgs-1, so maybe one goes on each side? If you
> can't find someone to look at the picture or drawing or whatever is on
> page 71 of the print manual, maybe a little trial and error is in
> order and see what fits best.
>
> Sorry I can't be of more help, but I had mine installed at HRO and
> never had my hands in there.
>
> 73, Steve KW3A
>
>
>
> On 11/18/2013 9:28 PM, Howard, W A 9 Y B W wrote:
>> Kent,
>>
>> I'm not sure you use the foam blocks in the 590. I don't remember
>> using them when mine was installed. Keep in mind that that board
>> goes in more then one model and the foam may be used in another model.
>>
>> Howard #3
>>
>> ----- Original Message -----
>> From: "Kent Plemmons" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Monday, November 18, 2013 6:03 PM
>> Subject: installing VGS1 on TS-590
>>
>>
>>> Good evening list,
>>>
>>>
>>>
>>> Can anyone instruct me regarding placement of the two small cushions
>>> that install on the VGS1 synthesizer for the Kenwood TS-590S?
>>>
>>>
>>>
>>> I know where the VGS1 installs and I have the proper two cushions. I
>>> don't
>>> know if one cushion installs on each side of the VGS1 or if they both
>>> install on the top of the synthesizer. Does anyone know?
>>>
>>>
>>>
>>> Thank you very much,
>>>
>>>
>>>
>>> Kent Plemmons
>>>
>>> Near Clyde NC
>>>
>>> KK4FFF
>>>
>>>
>>>
>>>
>>
>>
>>
|
