In addition to what Lloyd mentioned: It's made by tigertronics in (I
think) Oregon. It has 3 knobs on the front panel to do audio in and
out levels for rx and tx without having to go into the windows volume
control. Third knob sets the units internal vox delay.
The recent thread had to do with setting up one for a particular radio.
Jumpers need to be installed to configure for each radio. Dan had
purchased the optional jumper block to plug in, instead of doing the
several small wire jumpers.
73, Steve KW3A
On 6/5/2013 7:51 AM, Butch Bussen wrote:
> hmmm. What is a signalink?
> 73
> Butch
> WA0VJR
> Node 3148
> Wallace, ks.
>
>
> On Tue, 4 Jun 2013, DAN REID wrote:
>
>> Putting the plug and play chip in the signalink.
>> ----- Original Message -----=20
>> From: Butch Bussen<mailto:[log in to unmask]>=20
>> To: =
>> [log in to unmask]<mailto:[log in to unmask]>=20
>> Sent: Tuesday, June 04, 2013 5:27 PM
>> Subject: Re: signalink
>>
>>
>> I must have missed something, what are we taking apart?
>> 73
>> Butch
>> WA0VJR
>> Node 3148
>> Wallace, ks.
>>
>>
>> On Tue, 4 Jun=20
>> 2013, Steve Forst wrote:
>>
>> > There are 4 allen screws on the front panel and 4 on the rear. You =
>> want
>> > to remove the 4 from the front., then grab the front panel and pull =
>> it
>> > out . The front panel with knobs attached, and the circuit board =
>> will
>> > come out as one unit. If you remove the rear screws, all you do is =
>> get
>> > the rear panel off and the board remains inside the box.
>> >
>> > When you get the board out, lay it on a book or something so the
>> > attached front panel hangs over the edge. If that doesn't make
>> > sense, it will when you are holding the front panel/board assembly =
>> in
>> > your hand.
>> >
>> > There will be an allen key included in the package.
>> > 73, Steve KW3A
>> >
>> > On 6/4/2013 6:38 PM, DAN REID wrote:
>> >> DXE Engineering informs me that I need to remove four screws to =
>> install =3D
>> >> the plug and play chip. Are these screws in the front or back of =
>> the =3D
>> >> unit?
>> >> Thanks,
>> >> dan (kb6unc)
>> >>
>> >>
>> >>
>> >
>> >
>>
>>
>
>
>
|