hmmm.  What is a signalink?
73
Butch
WA0VJR
Node 3148
Wallace, ks.


On Tue, 4 Jun 2013, DAN REID wrote:

> Putting the plug and play chip in the signalink.
>  ----- Original Message -----=20
>  From: Butch Bussen<mailto:[log in to unmask]>=20
>  To: =
> [log in to unmask]<mailto:[log in to unmask]>=20
>  Sent: Tuesday, June 04, 2013 5:27 PM
>  Subject: Re: signalink
>
>
>  I must have missed something, what are we taking apart?
>  73
>  Butch
>  WA0VJR
>  Node 3148
>  Wallace, ks.
>
>
>  On Tue, 4 Jun=20
>  2013, Steve Forst wrote:
>
>  > There are 4 allen screws on the front panel and 4 on the rear.  You =
> want
>  > to remove the 4 from the front., then grab the front panel and pull =
> it
>  > out .  The front panel with knobs attached, and the circuit board =
> will
>  > come out as one unit.  If you remove the rear screws, all you do is =
> get
>  > the rear panel off and the board remains  inside the box.
>  >
>  > When you get the board out, lay it on a book or something so the
>  > attached front panel hangs over the edge.     If that doesn't make
>  > sense, it will when you are holding the  front panel/board assembly =
> in
>  > your hand.
>  >
>  > There will be an allen key included  in the package.
>  > 73, Steve KW3A
>  >
>  > On 6/4/2013 6:38 PM, DAN REID wrote:
>  >> DXE Engineering  informs me that I need to remove four screws to =
> install =3D
>  >> the plug and play chip.  Are these screws in the front or back of =
> the =3D
>  >> unit?
>  >> Thanks,
>  >> dan (kb6unc)
>  >>
>  >>
>  >>
>  >
>  >
>
>