Putting the plug and play chip in the signalink.
  ----- Original Message ----- 
  From: Butch Bussen<mailto:[log in to unmask]> 
  To: [log in to unmask]<mailto:[log in to unmask]> 
  Sent: Tuesday, June 04, 2013 5:27 PM
  Subject: Re: signalink


  I must have missed something, what are we taking apart?
  73
  Butch
  WA0VJR
  Node 3148
  Wallace, ks.


  On Tue, 4 Jun 
  2013, Steve Forst wrote:

  > There are 4 allen screws on the front panel and 4 on the rear.  You want
  > to remove the 4 from the front., then grab the front panel and pull it
  > out .  The front panel with knobs attached, and the circuit board will
  > come out as one unit.  If you remove the rear screws, all you do is get
  > the rear panel off and the board remains  inside the box.
  >
  > When you get the board out, lay it on a book or something so the
  > attached front panel hangs over the edge.     If that doesn't make
  > sense, it will when you are holding the  front panel/board assembly in
  > your hand.
  >
  > There will be an allen key included  in the package.
  > 73, Steve KW3A
  >
  > On 6/4/2013 6:38 PM, DAN REID wrote:
  >> DXE Engineering  informs me that I need to remove four screws to install =
  >> the plug and play chip.  Are these screws in the front or back of the =
  >> unit?
  >> Thanks,
  >> dan (kb6unc)
  >>
  >>
  >>
  >
  >