excellent. Thanks for the walk through. Hope to catch you on the air.
73,
dan (kb6unc)
----- Original Message -----
From: Steve Forst<mailto:[log in to unmask]>
To: [log in to unmask]<mailto:[log in to unmask]>
Sent: Tuesday, June 04, 2013 5:43 PM
Subject: Re: signalink
Good deal. No you won't need them, but it wouldn't hurt to hang on to
them. You could re wire for another radio without buying another module.
73, have fun, Steve KW3A
On 6/4/2013 7:37 PM, DAN REID wrote:
> Got the chip in. Since the chip is in, there isn't any need for the use =
> of the wires that came with the allen key, right?
> dan kb6unc
> ----- Original Message -----=20
> From: DAN REID<mailto:[log in to unmask]>=20<mailto:[log in to unmask]>
> To: =
> [log in to unmask]<mailto:[log in to unmask]>=20<mailto:[log in to unmask]:[log in to unmask]>
> Sent: Tuesday, June 04, 2013 5:22 PM
> Subject: Re: signalink
>
>
> Can you tell me where on the board the chip must go? Sorry!
> dan kb6unc
> ----- Original Message -----=3D20
> From: Steve =
> Forst<mailto:[log in to unmask]>=3D20<mailto:[log in to unmask]<mailto:[log in to unmask]:[log in to unmask]>>
> To: =3D
> =
> [log in to unmask]<mailto:[log in to unmask]>=3D20<mailto:[log in to unmask]:[log in to unmask]><=
> mailto:[log in to unmask]:[log in to unmask]<mailto:[log in to unmask]:[log in to unmask]>=
> RG%3E=3D20>
> Sent: Tuesday, June 04, 2013 5:08 PM
> Subject: Re: signalink
>
>
> There are 4 allen screws on the front panel and 4 on the rear. You =
> =3D
> want=3D20
> to remove the 4 from the front., then grab the front panel and pull =
> it =3D
>
> out . The front panel with knobs attached, and the circuit board =
> will =3D
>
> come out as one unit. If you remove the rear screws, all you do is =
> =3D
> get=3D20
> the rear panel off and the board remains inside the box.
>
> When you get the board out, lay it on a book or something so =
> the=3D20
> attached front panel hangs over the edge. If that doesn't =
> make=3D20
> sense, it will when you are holding the front panel/board assembly =
> in =3D
>
> your hand.
>
> There will be an allen key included in the package.
> 73, Steve KW3A
>
> On 6/4/2013 6:38 PM, DAN REID wrote:
> > DXE Engineering informs me that I need to remove four screws to =
> =3D
> install =3D3D
> > the plug and play chip. Are these screws in the front or back of =
> =3D
> the =3D3D
> > unit?
> > Thanks,
> > dan (kb6unc)
> >
> >
> >
>
>
>
|