Hi Christoph,
I was just checking to see how you are doing with your talking meter that
was not talking?
73
Howard #3
----- Original Message -----
From: "Howard, W A 9 Y B W" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, August 19, 2012 10:48 PM
Subject: Re: Talking Multimeter From NFB Independence Market
> Hi Christoph,
>
> The manual for the talking meter you referenced in your e-mail seems to be
> the correct manual for your meter.
>
> You shouldn't need to push any other button except the talk button to get
> your meter to talk.
>
> After you turn on the meter, you should hear some talking when you press
> the
> talk button no matter what position the big rotary function switch is set
> to
> other than of course off.
>
> I have found that the little talk button located on the positive (red)
> test
> lead doesn't always work.
>
> The volume may be turned down all the way on your meter.
>
> To adjust the volume, do the following:
>
> 1. Turn the meter over as if you were going to replace the batteries.
>
> 2. Orient the meter with the battery compartment away from you.
>
> 3. Lift up the little swing-out support stand.
>
> 4. In the recessed compartment that stores the stand there is a little
> volume control to the left of the stand's hinge.
>
> 5. Being gentle, using a small flat blade screwdriver turn the volume
> control clockwise to increase the talking volume. If the control is
> turned
> completely counter clockwise there is no talking.
>
> I hope this helps.
>
> 73
>
> Howard, W A 9 Y B W
>
>
>
>
>
>
>
>
> ----- Original Message -----
> From: "Christoph Bungard" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Friday, August 17, 2012 1:28 PM
> Subject: Talking Multimeter From NFB Independence Market
>
>
>> Hi everybody,
>>
>> yesterday, I finally received the package containing two talking
>> multimeters
>> (one for my neighbor and one for myself) that I had ordered from the NFB
>> Indepemdemce Market. It caught my attention that NFB had not supplied
>> the
>> manual in an accessible format. Anxious to get started, I then scanned
>> the
>> print manual, but the result wasn't as expected.
>>
>> I found a description of a talking multimeter right here:
>> http://www.accessible-devices.com/TalkingMultiMeterManual.html
>> However, I am unsure, if the multimeter described in this article is the
>> same model that I have now. Any help will be greatly appreciated.
>>
>> Also, one unit is working, the other is not, although the batteries are
>> OK.
>> The problem is that I actually don't quite remember how I got my unit to
>> speak, because it didn't work right after turning it on. I simply
>> pressed
>> the buttons randomly and was surprised I got it to work. Do you have to
>> press two or more buttons in a specific order to make the unit speak?
>>
>> 73 and thanks for your help,
>>
>> Christoph, DF9WM
|