 
| Sender: |
|
| Date: |
Tue, 4 Jun 2013 17:22:44 -0600 |
| Reply-To: |
|
| Message-ID: |
|
| Subject: |
|
| MIME-Version: |
1.0 |
| Content-Transfer-Encoding: |
quoted-printable |
| In-Reply-To: |
<CA.BF.10307.7737EA15@louvi-msg> |
| Content-Type: |
text/plain; charset="iso-8859-1" |
| From: |
|
| Parts/Attachments: |
|
|
Can you tell me where on the board the chip must go? Sorry!
dan kb6unc
----- Original Message -----
From: Steve Forst<mailto:[log in to unmask]>
To: [log in to unmask]<mailto:[log in to unmask]>
Sent: Tuesday, June 04, 2013 5:08 PM
Subject: Re: signalink
There are 4 allen screws on the front panel and 4 on the rear. You want
to remove the 4 from the front., then grab the front panel and pull it
out . The front panel with knobs attached, and the circuit board will
come out as one unit. If you remove the rear screws, all you do is get
the rear panel off and the board remains inside the box.
When you get the board out, lay it on a book or something so the
attached front panel hangs over the edge. If that doesn't make
sense, it will when you are holding the front panel/board assembly in
your hand.
There will be an allen key included in the package.
73, Steve KW3A
On 6/4/2013 6:38 PM, DAN REID wrote:
> DXE Engineering informs me that I need to remove four screws to install =
> the plug and play chip. Are these screws in the front or back of the =
> unit?
> Thanks,
> dan (kb6unc)
>
>
>
|
|
|
