It may have been DOA, but it may also be possible that something smoked when 
you installed the voice module.  I'm guessing either a static discharge, or 
the module was incorrectly plugged in.  You might try removing it to see if 
the radio works.

Steve

----- Original Message ----- 
From: "Steve Forst" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, July 25, 2012 11:39
Subject: Re: TS 480 sat is dead


> It's always possible it's DOA, but  you should recheck everything  a few
> times just to be sure you aren't overlooking something.
>
> I would do a full reset:
>
> Press and hold A=B key  while turning on the power.   A conformation
> message should come up on the display (don't remember if any voice
> output on this), hit the a=b key again to confirm the reset.  Hitting
> any other key will abort reset.
>
> Good luck, Steve KW3A
>
> On 7/25/2012 11:21 AM, Robert C wrote:
>> Brand new, all I did was install the voice chip. Finally got around to
>> having help with antennas and went to turn on the rig. Dead. We checked
>> all the obvious things. Power is getting into the radio. Swapped the
>> cable that connects the remote head to the tx/rx unit.
>>
>> I will have to contact Kenwood and see about sending it back in for
>> warranty work. In the meantime, has anyone had this happen?
>>
>> Quote of the nanosecond...
>> I saw a subliminal advertising executive, but only for a second.
>> Robert & Dreamer Doll  ke7nwn
>> E-mail-
>> [log in to unmask]
>> Home Page-
>> http://webpages.charter.net/dog_guide/
>>
>>
>>
>