Thanks again, Bob.
I think I'm ok now.
Tom Behler: KB8TYJ
----- Original Message -----
From: "Bob, K8LR" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, May 09, 2012 10:25 AM
Subject: Re: Dealing with loose mic connector in TS590
> The slotted nut that holds the mic connector on the front panel of the
> ts590
> is
> not even close to the pin field of the connector. The nut is outside of
> the
> connectors threaded shell.
> Bob, K8LR, [log in to unmask]
>
> ----- Original Message -----
> From: "Tom Behler" <[log in to unmask]>
> To: "Bob, K8LR" <[log in to unmask]>
> Sent: Wednesday, May 09, 2012 10:15 AM
> Subject: Re: Dealing with loose mic connector in TS590
>
>
> Yup!
>
> I found the slots in the nut, and used a small screw-driver to turn the
> nut
> until it was tight.
>
> I was concerned for a while that I might hurt the pin connections on the
> connector, but I guess they are independent of the nut.
>
> Tom Behler: KB8TYJ
>
> ----- Original Message -----
> From: "Bob, K8LR" <[log in to unmask]>
> To: "Tom Behler" <[log in to unmask]>; "blind ham radio operators"
> <[log in to unmask]>
> Sent: Wednesday, May 09, 2012 10:09 AM
> Subject: Re: Dealing with loose mic connector in TS590
>
>
>> Tom,
>>
>> were you able to tighten the connector?
>>
>> Bob, K8LR, [log in to unmask]
>>
>>
>
|