Tom,
I would try the other cable and also test a few other bands to see if
the problem is across the board.
If you do wind up doing a reset, I would check power output after the
reset, but before reloading your previous settings. That way you can
avoid the possibility of unknowingly reloading something that will cause
the same problem.
If you want to throw a steady carrier on CW (you said you weren't
sure how to do that), either just put a cable into the straight key jack
and short the wires, or use the TX tune function in the ARCP software.
I'm not sure how to get out of this in software, but hitting the send
button will put you back in RX.
73, Steve KW3A
On 12/10/2012 10:53 PM, Tom Behler wrote:
> Steve:
>
> My SWR on both the TS590 meter and the LDG talking watt meter is 1.0 to 1.
>
> I am working on what I know to be a resonant frequency on 40 meters, with my
> DXCC antenna.
>
> Also, I got the same readings when connected to a dummy load, both with and
> without my manual tuner.
>
> The re-set will be no problem, since I have all memories and rig settings
> saved.
>
> Will work on this again tomorrow night.
>
> Tom Behler: KB8TYJ
>
> ----- Original Message -----
> From: "Steve Forst" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Monday, December 10, 2012 10:42 PM
> Subject: Re: TS590 Output Power again
>
>
>> Tom,
>>
>> If you still have a 480 in the RV, it has the same molex end as the 590.
>>
>> What SWR are you showing on both the 590's SWR meter and the TW-1? I
>> find the TW-1 to be less than totally reliable.
>>
>> After tinkering and changing cables, you may get to a point where it is
>> just easier to try a reset. If you have the Kenwood software running,
>> you can back-up, reset, and restore your settings in less than 10
>> minutes. If it solves the problem, great. If not, you concentrate on
>> other things. While it is always possible it may need service,
>> usually this stuff turns out to be pilot error, bad metering, or some
>> other piece of gear in the system that has gone flukey.
>> 73, Steve KW3A
>
>
>
|