BLIND-HAMS Archives

For blind ham radio operators

BLIND-HAMS@LISTSERV.ICORS.ORG
Options: Use Forum View

Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
Re: Dealing with loose mic connector in TS590
From:
Tom Behler <[log in to unmask]>
Reply To:
For blind ham radio operators <[log in to unmask]>
Date:
Wed, 9 May 2012 13:41:34 -0400
Content-Type:
text/plain
Parts/Attachments:
text/plain (56 lines) 
    Thanks again, Bob.

I think I'm ok now.

Tom Behler: KB8TYJ

----- Original Message ----- 
From: "Bob, K8LR" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, May 09, 2012 10:25 AM
Subject: Re: Dealing with loose mic connector in TS590


> The slotted nut that holds the mic connector on the front panel of the 
> ts590
> is
> not even close to the pin field of the connector.  The nut is outside of 
> the
> connectors threaded shell.
> Bob, K8LR, [log in to unmask]
>
> ----- Original Message ----- 
> From: "Tom Behler" <[log in to unmask]>
> To: "Bob, K8LR" <[log in to unmask]>
> Sent: Wednesday, May 09, 2012 10:15 AM
> Subject: Re: Dealing with loose mic connector in TS590
>
>
>    Yup!
>
> I found the slots in the nut, and used a small screw-driver to turn the 
> nut
> until it was tight.
>
> I was concerned for a while that I might hurt the pin connections on the
> connector, but I guess they are independent of the nut.
>
> Tom Behler: KB8TYJ
>
> ----- Original Message ----- 
> From: "Bob, K8LR" <[log in to unmask]>
> To: "Tom Behler" <[log in to unmask]>; "blind ham radio operators"
> <[log in to unmask]>
> Sent: Wednesday, May 09, 2012 10:09 AM
> Subject: Re: Dealing with loose mic connector in TS590
>
>
>> Tom,
>>
>> were you able to tighten the connector?
>>
>> Bob, K8LR, [log in to unmask]
>>
>>
>

ATOM RSS1 RSS2