In a message dated 11/12/98 4:14:27 PM Eastern Standard Time,
[log in to unmask] writes:
<< Hi,
I have an old 8088 which I have taken out after a long time. On booting I
get the display and the RAM test but get a short beep and error code 1701
and the system halts.
I am unable to figure out what is wrong.
Please help.
Thanks
Ashok Bhiman
[log in to unmask] >>
Hi,
You say it has been sitting a long time......chances are good the CMOS
battery has died, and all CMOS settings are lost, therefore the errors on
bootup. You can reset the CMOS settings, but until you replace the battery, it
will "forget" them every time you turn the computer off.
HTH,
Peter Hogan
[log in to unmask]
PCBUILD only works if you contribute. Send your messages
to be posted to: [log in to unmask]